Please first make sure that both the USB connector and USB cable are free from water, dust, and sand..

Connect the USB cable to your computer and then to Motion.

Press the lower-right button multiple times until the Connect to PC menu shows up.

Press the lower-center button to enter the Connect to PC menu.

A very short popup should display "Connect to computer". Motion has started USB negotiations with your computer.

Once done, the popup will display "Connected to computer".

Your operating system will display Motion as an USB Mass Storage disk.

Download the newest firmware, named Motion.bin, from the Downloads page and place it in the disk drive.

To exit safely, the preferred method is to select the disk drive and choose your operating system variation of "Eject safely".
Or, press both upper-right and lower-center buttons on Motion.

Motion will notice the new Motion.bin firmware file and will shut down.

You will have to restart Motion yourself by pressing the lower-center button for five seconds.

Motion, now in safe-mode, will update itself.

The installation was successful and Motion will use the new firmware from now on.

If, instead, a message similar to "Error 0x0A" appears, please send us an email at : support@motion-gps.com Don't worry, we've never had one bricked.

Last but not least, please remember to place the USB silicone dust plugs back over the USB connector.