Motion
 
 
Connect the USB cable
Please first make sure that both the USB connector and USB cable are free from water, dust, and sand..

Connect the USB cable to your computer and then to Motion.
 
Map
 
Navigate to "Connect to PC"
Press the lower-right button multiple times until the Connect to PC menu shows up.

 
Connect to PC
 
Enter the "Connect to PC" menu
Press the lower-center button to enter the Connect to PC menu.

 
Connect to
computer
Connect to PC
 
 
"Connect to computer" popup
A very short popup should display "Connect to computer". Motion has started USB negotiations with your computer.
 
Connected to
computer
Connect to PC
 
 
"Connected to computer" popup
Once done, the popup will display "Connected to computer".
 
 
 
 
USB Mass Storage disk
Your operating system will display Motion as an USB Mass Storage disk.
 
 
 
 
Download the newest firmware
Download the newest firmware, named Motion.bin, from the Downloads page and place it in the disk drive.
 
 
 
 
Exiting safely
To exit safely, the preferred method is to select the disk drive and choose your operating system variation of "Eject safely".
Or, press both upper-right and lower-center buttons on Motion.
 
Firmware
update
Connect to PC
 
 
"Firmware update" popup
Motion will notice the new Motion.bin firmware file and will shut down.
 
 
 
 
Restart Motion
You will have to restart Motion yourself by pressing the lower-center button for five seconds.
 
Loading
New firmware
 
 
Actual firmware update
Motion, now in safe-mode, will update itself.
 
The installation was successful
New firmware
 
 
It's done
The installation was successful and Motion will use the new firmware from now on.

If, instead, a message similar to "Error 0x0A" appears, please send us an email at : support@motion-gps.com Don't worry, we've never had one bricked.

Last but not least, please remember to place the USB silicone dust plugs back over the USB connector.